auxiliary
FX I and FX II send tracks
and hold the two send effects: any sounding track can feed them, FX I can feed FX II (one way only), and or opens the effect list for a slot.
One reverb on FX II can serve every track, each sending as much as it needs, and chaining FX I into FX II lets a delay fade into reverb. The chain only runs that way round, so reverb into delay means loading the reverb on FX I and the delay on FX II. The effects themselves are described in the effects area.
Details
- TE’s guide
FX I and FX II are the two send effects; every track that makes sound can send to both, and FX I can send on into FX II.
- TE’s guide
On an FX track the keyboard plays the last selected instrument track, so you hear the effect on that sound.
- TE’s guide
or opens the effect list for that slot: scrolls it, and or loads the highlighted effect.
- TE’s guide
On an FX track, shows the loaded effect's parameters.
- TE’s guide
On FX I, on the page sets the send into FX II.
- worked out
The link between the slots runs one way, FX I into FX II; the guide describes no send from FX II back into FX I, so put the effect that should come first on FX I.
- worked out
What FX II's own shift layer holds is not documented, and that page has not yet been looked at on a unit.
- TE’s guide
Instrument tracks send from their send page ( held on , for FX I, for FX II).
- TE’s guide
In mix mode, sets each track's FX I send with and FX II send with .
- worked out
The guide's FX routing card repeats a CV sentence and its filter card names the tape track — copy slips.
- checked on a unit · 1.1.33
The FX I page is headed with a boxed FX I and the effect's name, then four columns with labels above and values below, each a bar split by a marker at the value's height.
- checked on a unit · 1.1.33
On FX I, lists the effects — chorus, delay, dist, lofi, phaser and reverb.
- checked on a unit · 1.1.33
Over MIDI, CC12–15 on channel 15 move the four columns of FX I.