recipes
Play an external synth over MIDI
Set the multi-out to midi before plugging in a TRS-to-DIN cable (USB gear needs no setting), then play and sequence the synth from in auxiliary mode on the synth's channel, set on . TE's steps set no project MIDI channel; set clock to both only if the synth should follow the tempo.
If nothing sounds, check the channel first, then the cable route (multi-out mode, adapter type) and, for USB gear, the device's switches under . Leave the project's midi page alone unless a track on an OP-XY engine should send its notes too. Notes need no clock: switch clock to both only when the synth's tempo-synced parts should lock to the OP-XY. Bluetooth MIDI synths work too once the OP-XY advertises itself from the com page.
How to
Point the external MIDI track at a synth
before you start nothing is plugged into the multi-out yet
- 1 midi; then connect the cable
- 2 the synth's MIDI channel
Control a synth parameter by CC
- 1
- 2 switch the slot on, choose the CC number
- 3 send values
Let the synth follow the OP-XY's tempo and transport
- 1
- 2 the midi section
- 3 clock
- 4 both
and send start and stop, and clock ticks run continuously (checked over USB).
Details
- TE’s guide
Synths with DIN MIDI sockets need the multi-out set to midi and a type A TRS-to-DIN cable, DIN end into the synth, jack into the multi-out.
- TE’s guide
The multi-out does one job at a time, so in midi mode it carries no CV, gate, sync pulse or audio.
- TE’s guide
Synths with USB MIDI plug into the OP-XY's USB-C port (through an adapter if needed), need no multi-out setting and appear under .
- TE’s guide
TE's how-tos point to the devices page () only for USB gear; whether a synth on the multi-out appears there is not documented.
- TE’s guide
The external MIDI track is in auxiliary mode; its keyboard and sequencer play the connected synth.
- TE’s guide
On the track's page, sets the MIDI channel — match the channel the synth listens on — while and pick bank and program.
- TE’s guide
TE's steps set only that channel; the project's midi page () is not part of them.
- community
Community tools also report that the external MIDI track and midi-engine tracks send without a project MIDI channel; not yet checked on a unit.
- checked on a unit · 1.1.33
On a unit with stock settings, notes in the midi section of the system settings () is at both, which includes sending.
- checked on a unit · 1.1.33
Clock is its own switch in the same section; at the stock setting (in) and send no start, stop or clock ticks, and set to both they send start and stop with a constant tick stream (seen over USB).
- community
Community tools report that clock, start and stop go out over TRS MIDI as well as USB under that switch; only USB has been checked on a unit.
- TE’s guide
and hold eight CC slots: plus an encoder switches a slot on and picks its CC number, turning the encoder sends values, and the moves can be sequenced and recorded.
- TE’s changelog
To sequence several synths, instrument tracks can run the midi engine too; TE's guide still calls it "external", its name before OS 1.0.15.
- checked on a unit · 1.1.33
On OS 1.1.33 the preset browser listed no midi engine, so is the route to use on that firmware.
- community
To send the notes of a track on one of the OP-XY's own engines as well, community tools say to give it a channel on the project's midi page.