effects
Phaser effect
A 12-pole phaser for FX I or FX II; sets the centre frequency of the sweep, its depth, its rate and the feedback.
A phaser gives a sound a slow, swirling motion. Frequency places the sweep, depth sets how far it travels and rate how fast. With feedback low the effect is gentle; turned up it becomes a pronounced, whistling resonance. It suits pads, chords and hi-hats.
Details
- TE’s guide
The phaser blends filtered copies of the sound with the dry signal; where the two are out of phase they cancel, which carves moving notches into the spectrum.
- TE’s guide
The phaser is a 12-pole design with 12 notches.
- TE’s guide
More feedback () sends more of the phaser's output back into it, making the sweep ring and sing.
- checked on a unit · 1.1.33
The phaser's columns read frequency, depth, rate and feedback, as the guide names them.
- community
The rate runs on one exponential curve from about 0.005 Hz at 0 to about 15 Hz at 99; one sweep takes about 2 s at rate 58, 1.4 s at 62, half a second at 75 and a fifth of a second at 84, and above about 90 the sweep is a wash rather than a movement (one video, OS 1.0, read from the ringing at high feedback).
- community
Feedback reaches about 0.9 at 99, enough for the notches to ring and sing; lower settings give a gentle effect.
- community
A phaser page opens on frequency 30, depth 61, rate 30 and feedback 50; frequency is the least certain of the four (one video, OS 1.0).
Parameters
| parameter | gesture | range | cc |
|---|---|---|---|
| frequency M1 | – | 12 | |
| depth M1 | – | 13 | |
| rate M1 | – | 14 | |
| feedback M1 | – | 15 |