mix
Master saturator
Mix is a saturator on the master bus; gain drives it, clip shaves off loud peaks, tone filters highs or lows and mix sets how much of it you hear.
The saturator adds density and warmth to the finished mix. Gain drives it, clip keeps peaks in check and tone tilts the result darker or brighter; mix blends it with the clean signal, so heavy settings work in small doses. It sits after the EQ and before the compressor.
How to
Open the master saturator
- 1
Details
- TE’s guide
The saturator on mix works on the master, so it colours the whole mix.
- TE’s guide
Clip () flattens the loudest peaks, reining in the dynamics.
- TE’s guide
Mix () sets how much of the saturated signal you hear in the master.
- community
Raising gain does not make the mix louder - on OS 1.0 with mix at 54 to 71 and clip at 23 the output stayed within about 1 dB of the clean mix up to gain 62. With clip at 53 to 79 the level fell 2.5 to 5 dB, all of it in the bass below 250 Hz, and the crest factor did not change; a recording on OS 1.1.x (gain 43, clip 60, mix 58) kept the level and had a brighter top by 3 to 4 dB, so the two disagree about what higher settings do.
- community
No MIDI CC is known for the master saturator.
- checked on a unit · 1.1.33
The saturator page shows four vertical tick ladders — gain, clip, tone and mix from left to right — each topped by a cap in its encoder's style.
- community
Clicking , the mix encoder, resets the mix to nothing, and the slider drops to the bottom at once; the narration describes it as clicking the encoder to reset it (one video, OS 1.1.x; not on OS 1.0).
Parameters
| parameter | gesture | range | cc |
|---|---|---|---|
| gain M3 | – | – | |
| clip M3 | – | – | |
| tone M3 | – | – | |
| mix M3 | – | – |